HDi Ford Ranger/Mazda Bt50 stage 2 complete intercooer kit & Automatic transmission cooling kit is designed for better temperature maintenance of the Automatic transmission fluid and increased performance and reduce in fuel consumption!, especially under heavy towing or under a heavy load.Unlike others that made from a low quality universal intercooler cut and weld pipes to adapt to the car.
The HDi intercooler kit is specifically for the Ford Ranger/Mazda Bt50 to its maximum cooling potential. The HDi intercooler kit is full aluminum design not like the OEM that uses plastic side tank .HDi Intercooler kits are also Dyno proven in many countries toto improve 6hp-15hp horse power and 10nm-20nm of torque throughout the rpm range!
The automatic transmission tested have shown 10-15 Degrees C lower in peak temperature as well as more solid in-gear torque transfer.The better maintaining in transmission oil temperature is known as an effective way for extension of the transmissions life. A must for all tradesman.
The HDi Ford Ranger/Mazda Bt50 complete stage 2 kit is to replacing the regular Chemical polished water to oil factory unit via a Design registered adaptor make it easy to fit and make it a perfect integration with the Chemical polished OEM ATF cooler. And the intercooler kit is easily installed with basic workshop tools, installation is a quick and easyprocess normally it takes less than 40 minutes
***Ford Everest needs hot pipe and cold pipe to fit!!***
Performance is guaranteed
Ford Ranger/Mazda Bt50 complete stage 2 kit benefit as below:
- Reduce heavy load peak temperature
- Solid transmission torque transfer
- Reduce torque slip due to overheating
- Easy to install
- Extend transmission operation life
- Improve fuel efficiency by reducing transmission slippage due to over heating
- Fully integrated with Chemical polished transmission cooler system
- Perfect for boosted up, tuned and modified engines
- Best value for money
- High quality side tank with Fluid dynamic cad design for your best flow guaranty
The HDi Ford Ranger/Mazda Bt50 complete stage 2 kit comes with all needed components for completing installation. Including a HDi high quality oil cooler and intercooler, high pressure hydraulic braded hose and professional fittings for the toughest working condition.
The Full stainless steel screws and brackets the best durability against water and salt corrosion.
The special design allowing enough area for aftermarket 4wd winch to be installed
It also allows good air flow to the radiator! Perfect for installing with HDi GT2 intercooler kit The reduced inlet restriction and inlet temperature provides higher density of oxygen for better combustion with the same amount of fuel. Therefore, increase mileage!
It is absolutely the best Ford Ranger and Mazda BT50 package for
HDi Ford Ranger/Mazda Bt-50 Stage 2 Intercooler Kit&Auto Transmission Cooler Kit
The HDi Ford Ranger/Mazda Bt50 GT2 benefit as below:
Improved low end throttle response (refer dyno)
Minimal pressure drop despite large intercooler sizing (thanks to HDi GT2 technology)
Increased torque range at low end (refer dyno)
Reduction of both inlet temperatures
less engine running temperatures
Increased performance
Better reliability and consistency
Increase power throughout entire RPM range (not only focusing on the PEAK)
Improve fuel efficiency*
Best value for money
Performance guaranteed!
The kit comes with HDi reinforced Silicon hose to replace the Chemical polished Rubber hose which prompt to expand and split.
Full stainless steel screws and brackets the best durability against water and salt corrosion.
The special design allowing enough area for aftermarket 4wd winch to be installed
It also allows good air flow to the radiator!
*The reduced inlet restriction and inlet temperature provides higher density of oxygen for better combustion with the same amount of fuel. Hence, increase mileage!